Hydro Standard-Length Spacers

The Standard-Length Spacer is one of several customization options that changes the aesthetic, balance, and sound of your Hydro. These spacers have built-in jimping around the perimeter to assist with tricks like the Infinity Ladder.

The Standard-Length Spacer is lighter than the Full-Length Spacer which produces a faster, neutral balance point. To fine-tune the balance even further, we recommend experimenting with the Hydro Titanium Hardware Kit.

The Pre-Production and First Production Hydro come equipped with a Standard-Length Ultem spacer. The G10 spacers are slightly heavier than the Ultem, which will provide a small amount of additional handle bias.

Installation of the Standard-Length spacers is quick and easy as it only requires two standard T10 Torx drivers. You’ll first need to remove the top and bottom screw of each handle. We recommend using one T10 torx driver to hold the pivot while using a second T10 torx driver to unscrew the screw (the shinier side). Once the screws are removed, you only need to pull off one slab of each handle. Slide the bottom pivot into the hole of the spacer while also aligning the two locating bosses along the edge of the handle. Make sure to press firmly to ensure that the spacer is sitting flat against the handle. Once the spacer is placed, you can put the handle slab back on. Re-threadlock the screws and then reinstall the screws the same way that they were removed. 

Includes:

2 x Full Length Spacers

• Built-in jimping
• Modifies the balance point
• Easily and quickly installs in minutes with no special tools